sd25 nissan 4 cyl need timing pattern?

Vehicles powered by Nissan six-cylinder SD diesel engines.

Moderators: plenzen, Nissan_Ranger

Post Reply
openrange
Posts: 1
Joined: 12 years ago

sd25 nissan 4 cyl need timing pattern?

#1

Post by openrange »

looking for info on setting the timing on my sd25 in a forklift
plenzen
Posts: 890
Joined: 16 years ago
Location: Cochrane Alberta Canada

#2

Post by plenzen »

Here from the FSM that I have for SD25 in Truck application.
Assuming that pump has been removed and reinstalled
#1. Confirm that #1 piston is at T.D.C on Compression Stroke
#2. Install Injection pump
(1) Temporarily set injection pump so that flange of pump is aligned with the aligning mark on front cover
(2) install injection pump drive gear ( 59 - 69 N-m ( 43-51 ft-lb)
Install cover, adjust plunger lift

Plunger Lift Adjustment
1. Remove plug bolt from distributor head and install dial gauge
2. Set cold start device so it does not operate
a. turn CSD linkage clockwise
b.Set block length about 15mm ( 0.59in) between CSD and linkage
3. Adjust and measure plunger lift
(1.) Turn crankshaft counterclockwise 20 to 25 degrees from No.1 Piston at T.D.C
(2.) Find dial gauge's needle rest position at step (1) set postiion, then set gauge to zero
(3.) Turn crankshaft clockwise until No.1 piston is set at T.D.C.
(4.) Read dial gauge indication.
Plunger lift 0.95 -0.99 mm ( 0.0374 - 0.0390 in )
(5.) If dial gauge in not within the above range, turn pump body until it falls within standard range
a. If indication is smaller than the specified value, turn pump body
counterclockwise
b. If indication is larger then turn pump body clockwise
4. Tighten pump to 20 - 25 N-m ( 14 - 17 ft.lb.
5. Disconnect dial gauge and install plug with new bolt and washer 16 - 22 N-m ( 12 - 16 ft.lb)
Warning:
After plunger lift adjustment, mark aligning marks on injection pump flange and front plate.
6. Connect injection tubes, yada yada yada
it goes on from there about bleeding system etc.


Under the S.D.S Specs it states:
INJECTION TIMING
Plunger lift 0.95 - 0.99mm
( 0.0374 - 0.0390 in )
(equivalent to 6 degrees B.T.D.C. )
HTH

Paul
Retired Pauly
Problem with being retired is that you never get a day off.
1987 D21-J SD25 KC
KJLGD21FN
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests