Pneumatic Governor Diaphragm Too Thick?

SD diesels were widely available in the US in the 1981-86 Datsun/Nissan 720 pickups, and in Canada through '87 in the D21 pickup.

Moderators: plenzen, Nissan_Ranger

Post Reply
mbehensky
Posts: 4
Joined: 12 years ago
Location: Soquel, CA

Pneumatic Governor Diaphragm Too Thick?

#1

Post by mbehensky »

When I ordered the pneumatic governor diaphragm for my 1981 pickup from southwest diesel, they asked me for my pump number. I told them, but they couldn't find it in their book. They had numbers both slightly below and slightly above the one on mine, though. I asked, and both these pumps used the same diaphragm part number. I figured that mine would be the same and ordered that part. (Seems to be the same one phillip got for his truck, Zexel 155020-7920).

Image

After I put the diaphragm in and started screwing the cover back on, I found that I couldn't screw the cover down tight. Taking the cover back off, I noticed that the metal rim around the diaphragm was slightly thicker on the new diaphragm.

I tightened the screws up somewhat (I didn't go too tight so I didn't snap one of the ears off the cover), and tried the truck out. I needed to re-adjust the idle speed, but it ran great.

Am I just supposed to tighten the thing down hard and compress the rim, or do I in fact have the wrong part? I guess I could try ordering it through my dealer and see what I get...


Image
1981 Datsun 2wd pickup
1982 Mercedes 240D
1987 Mercedes 300D wagon (cracked head)
1981 Mercedes 300D 2.5 Turbo (bad transmission)
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests