Pics of turbo manifold and turbo. Manifold is built from schedule 40 black pipe and elbows. Original application for turbo was a Pontiac Sunfire 1.9l. It has a water cooling jacket as well as oil. The turbine and compressor AR/s are just a smidge smaller that those used on the VW 1.9 from the factory. I think this will be OK, as the VW certainly revs higher than the SD.....
Also, I got the pics to work on my MZ governor thread in the SD2X engines section if there is any interest.
(click on any image for larger)
Sd22 Turbo Project
Moderators: goglio704, Nissan_Ranger
-
- Posts: 95
- Joined: 18 years ago
- Location: Illinois, USA
-
- Posts: 207
- Joined: 19 years ago
- Location: Florence, AZ
Very nice work and do you think you'd be interested in making a custom turbo manifold for a C223 Isuzu diesel engine? Thanks.
Sal
Sal
1982 Datsun Maxima diesel wagon w/ 228k miles
*occasional daily driver*
1982 Datsun Maxima diesel sedan w/ 252k miles
*now off the road as a parts car and sent to the yard *
*occasional daily driver*
1982 Datsun Maxima diesel sedan w/ 252k miles
*now off the road as a parts car and sent to the yard *
-
- Posts: 23
- Joined: 13 years ago
- Location: Middleburg, Fla., U.S. of A.
GREETINGS!
Man, that is one sweet install.
Nice, clean work.
I want to build a header that will stand the heat, but didn't think of using BIP. That should last!
BIP should be easy to bend & work, too.
Custom 1/2" flanges?
UPDATE?
How's the Turbo match SD22 RPM band?
Any details to share now that some time has past?
Looking back, is there anything you'd do differently?
Thanks,
Man, that is one sweet install.
Nice, clean work.
I want to build a header that will stand the heat, but didn't think of using BIP. That should last!
BIP should be easy to bend & work, too.
Custom 1/2" flanges?
UPDATE?
How's the Turbo match SD22 RPM band?
Any details to share now that some time has past?
Looking back, is there anything you'd do differently?
Thanks,
'82 DATSUN 720 SD22, '77 Fiat 124 Spider, '81 Toyota HiLux, '64 Chevy Corvair Monza
The Blessing of Abraham is mine!
The Blessing of Abraham is mine!
-
- Posts: 19
- Joined: 12 years ago
- Location: Sisters, OR
I made one of this style manifold for my SD22 turbo build and it works awesome! I used forged steam fitting bends. They are far tighter radius than could ever be achieved by bending straight pipe and being schedule 40 forged steel, much stronger too. I just bought 90 degree bends and cut them to the right angles with an angle grinder. Then I cut the flanges off the stock manifold and welded straight to them.
Who is online
Users browsing this forum: No registered users and 3 guests