Manual transmission vehicles actually use three of these. 2 on the brake pedal and 1 on the clutch pedal.
With a little luck, I will never have to look it up in FAST again.
Brake light switch bumper on pedal
Moderators: plenzen, glenlloyd, goglio704, Nissan_Ranger
-
goglio704
- Posts: 726
- Joined: 19 years ago
- Location: East Tennessee
Brake light switch bumper on pedal
The part number for the push in rubber bumper on the brake pedal that operates the brake light switch is 46584-S0100 .
Manual transmission vehicles actually use three of these. 2 on the brake pedal and 1 on the clutch pedal.
With a little luck, I will never have to look it up in FAST again.
Manual transmission vehicles actually use three of these. 2 on the brake pedal and 1 on the clutch pedal.
With a little luck, I will never have to look it up in FAST again.
Matt B.
83 Maxima Sedan, LD28, 5 speed, white, 130k miles. My original Maxima.
83 Maxima Sedan converted from gasser, LD28, 5 speed, 2 tone blue, 230k miles
82 Maxima Sedan, LD28, 3 speed auto, 2 tone Gray/Silver, 140k miles
81 810 Sedan, LD28, 3 speed auto, rust, rust, and more rust!
2005 Jeep Liberty CRD
83 Maxima Sedan, LD28, 5 speed, white, 130k miles. My original Maxima.
83 Maxima Sedan converted from gasser, LD28, 5 speed, 2 tone blue, 230k miles
82 Maxima Sedan, LD28, 3 speed auto, 2 tone Gray/Silver, 140k miles
81 810 Sedan, LD28, 3 speed auto, rust, rust, and more rust!
2005 Jeep Liberty CRD
-
Dslsmoke
- Posts: 33
- Joined: 19 years ago
- Location: Hialeah Fla.
Brake light switch bumper on pedal
Well I remember a loooooong time ago while traveling thru the Carolinas, I lost my CC, 
When I pulled over to rest a bit, I noticed the brake lights were "ON ! "
After a little roadside engineering !
the problems was fixed.
All it took was 2 pennies and a piece of electrical tape and WHALA!
Just staked the coins over the whole on the pedal wrapped it with tape and had stop lights and CC again....
Dslsmoke
When I pulled over to rest a bit, I noticed the brake lights were "ON ! "
After a little roadside engineering !
the problems was fixed. All it took was 2 pennies and a piece of electrical tape and WHALA!
Just staked the coins over the whole on the pedal wrapped it with tape and had stop lights and CC again....
Dslsmoke
Who is online
Users browsing this forum: No registered users and 1 guest